Plantronics CT10 User Manual download pdf (Page 13)

Put on the Headset , and adjust the band until it rests with almost no

pressure on your ear and the top of your head.

If the headset is too loose, remove it and gently push the headset band

inward slightly to tighten it. If the headset is tight, gently pull the headset

band out to loosen it.

The microphone boom can be swiveled to position the headset on either

your right or left ear by rotating it up over the head.

Use one hand to hold the headset in place. Adjust the microphone boom

until it is about 1 inch from the side of your mouth. Do not twist the

microphone on the end of the boom as this may damage the internal

wiring.

Use the Clothing Clip to attach the headset cord to your lapel or collar

and out of your way.

Leave enough slack in the headset cord so that you can move your head

freely.

SETUP THE HEADSET

The Pulse/Tone Switch is located under the Base simply push the

switch to Pulse or Tone as desired or required by your telephone service.

PULSE/TONE SWITCH

STEP 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 135 136

No comments

Plantronics CT10 User Manual Page 13