Plantronics CS351N / HL10 Installation Manual download pdf (Page 5)

6“

12”

The minimum recommended separation distance is shown above.

Important: Incorrect positioning can cause noise and interference problems.

1. Slide headset into charging cradle;

he earpiece with the microphone

goes into the cradle.

. Gently press down on the headset

to ensure that headset is in correct

position. Amber charge indicator

light on base will flash while

charging and will change to solid

amber when fully charged.

• 20 minutes = minimum

chargeto continue setup

• 3 hours = full charge

IntelliStand

™

off

IntelliStand

Set the IntelliStand switch to

IntelliStand off (

—) if you

want to control the handset

lifter with the call control

button on your headset.

Set the IntelliStand switch to

IntelliStand on (

) if you want

the handset to automatically

pick up when you take the

headset off the charging cradle.

1. Plug handset lifter power cord into handset lifter jack on base. Push firmly into

base.

2. Position handset lifter under the handset on your phone. Verify that the lifter is

located on top of the telephone speaker. If not, you will need to attach the ringer

microphone as described on page 22.

NOTE: Remove only a tiny piece of mounting tape backing to temporarily stick lifter into

position; you may need to move it later.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Plantronics CS351N / HL10 Installation Manual Page 5